Hook Installation
Original Snughook Installation
When you purchase the Original Snughook from Snughooks, you will receive:
- An injection moulded Snughook
- Backing Plate
- Four Screws and wall plugs (for installation into brick)
- Two square drive security screws
Step 1
Grab the backing plate and move it into the desired position for installation. Level the backing plate and then mark the drill hole positions with a pencil.
Step 2
Using the four screws and wall plugs, fix the backing plate to the wall (with one screw going into each corner of the plate).
*When placing more than one hook in a line, please ensure that you leave a 10mm gap between backing sheets to allow the moulded sections to fit next to each other.
Step 3
Slide the moulded section from the top corner, over both flanges until it sits firmly on the backing plate. use a soft faced hammer to tap it into position if required.
Step 4
Fit two security screws into the pre drilled holes with a square drive drill bit.
You have now correctly assembled the Snughooks! If you are experiencing any issues, please watch the video, or get in touch with us at sales@snughooks.com
Video
If you require more information or guidance, please watch the video below.